6/4/2023 0 Comments Readynas acrosyncGenerally, this goes in ~/.ssh/authorized_keys of your destination. A text file will be downloaded with the public key.Edit the backup job you created by clicking Settings.Click Download SSH key file to get the public key from the ReadyNAS.Ī text file will be downloaded with the public key.If disabled, check the box to Enable SSH.In the ReadyNAS Admin Page, navigate to System > Settings, and click SSH.Now, you need to give the public key from the ReadyNAS and attach it to the authorized_keys file of your remote SSH connection. Optionally, configure the schedule of this backup job.You can hit test connection to confirm connection, but you'll need the public key added to the destination first. Enter host, any custom port (if applicable) share (path), and the username to connect to on the other side. Select remote: Rsync over Remote SSH to use the rsync over SSH options.Follow the below steps for configuring an rsync over SSH job. You can use the ReadyNAS to pull data from a server or push data to a server that is running rsync over SSH. There are two ways to use Rsync over Remote SSH: using the ReadyNAS to push or pull data or using a remote server to push or pull data with the ReadyNAS.Ĭreating an Rsync over SSH backup job on the ReadyNAS Admin Page # -ĭont compress = *.gz *.tgz *.zip *.z *.Z *.rpm *.deb *.Not what you're looking for? Return to the ReadyNAS Backup FAQ chmod 664 rntwo My final nf file # /etc/rsyncd: configuration file for rsync daemon mode In your nf file make sure that chroot = false use chroot = false chdir failedĮnsure that the directory has the correct permissions allocated. Inside this configuration files are various module definitions (specifying the path etc), the module must be chroot failed I was editing /etc/nf when it should have been /etc/nf. I was having an issue whereby the config file i was using wasn’t being picked up by rsync (typo). The path must only represent the module defined in the nf file – not the directory Unknown module ‘mnt’ This should match the username you are using in the Readynas and the nf file chown -R user1 /datadisk/mynasfiles ERROR: The remote path must start with a module name not a / This statement changes the ownership (recursively) of the directory to user1. However the solution was that the username my Readynas was using was not the owner of the directory. Most of the solutions on the web tell you to use the -O flag to omit updating directory times. Rsync: failed to set times on "." (in frontbut): Operation not permitted (1)Īt first i thought this problem was because of the way i was mounting Azure files and that it’s filesystem didn’t support it. The quick command to get it running is rsync -daemon rsync: failed to set times on “.” (in frontbut): Operation not permitted (1) sending incremental file list It turned out that my rsync daemon wasn’t listening correctly. rsync: getaddrinfo: .com 873: Name or service not known Here’s a run down of a bunch of the errors i received when doing this and how to get around them. Ideally in Azure files as my data will be the most accessible to me over an smb share in the same way that i’ve always accessed my ReadyNas devices. My desired location for the data backup is in Azure (naturally!). Thusly the only other way to get the job done is to use rsync. I’d normally opt for the simplicity of CIFS/Samba, but my internet provider has decided to block those ports and the Readynas devices don’t allow you to use a non-standard port. They’re pretty basic, but offered good squeezebox support and a cheap way of me storing TB of data in a RAID config.īoth of the Readynas devices support backup operations to send their data on a scheduled basis. Years ago i bought a couple of Netgear Readynas devices.
0 Comments
Leave a Reply. |